Introduction; What Are These Symbols; Functionality Of The Backup Camera System; Intended Use - AEG RC 3.5 Notice D'utilisation

16

1.0 INTRODUCTION

Dear customer,
Congratulations, you have purchased a new „RV
3.5 backup camera system". Thank you for your
trust. To ensure optimal function, performance and
safety of your backup camera system please read
the instructions for use prior to initial use. This will
ensure you will be able to enjoy this equipment
for a long time.

1.1 What are these symbols?

Refer to operator's manual
Attention - Danger! Follow safety
instructions and warnings!
Warning – dangerous voltage!
Risk of fatal injury!
Caution! Risk of electrical voltage
around components inside the vehicle!
Dispose of equipment, batteries and
packaging in an environmentally
friendly manner!
This equipment complies with
EU directives
Tested according to ECE
E
24
10R-03 0813
Refer to page 26 for additional information
about symbols, units and abbreviations.
1.2 Functionality of the backup camera
system
The RV 3.5 backup camera system assists with
visibility when briefly reversing, e.g. when
parking. Pressing the on / off switch will activate
the color monitor and, with the car in reverse, the
camera picture is wirelessly transmitted from the
sender to the monitor. The camera angle of view
is 110 °. The built-in night vision technology also
allows image transmission in the dark. When
shifting out of reverse gear, the transmitter will
stop transmitting the signal and the monitor image
disappears.

1.3 Intended use

The RV 3.5 backup camera system is solely
intended to further assist with visibility whilst
briefly reversing with a vehicle.
The RV 3.5 backup camera system does not
release you of your duty to follow traffic regu-
lations of the Road Traffic Act (RTA) and your
due diligence. This backup camera is intended
for maximum backup speeds of 3 km/h (kilo-
meters per hour) and a maximum transmission
range of 10 m.
The backup camera system is solely intended for
private use. The backup camera is solely intended
to assist with visibility when reversing with a
vehicle. It does not release you of your due dili-
gence to drive carefully and to look around when
reversing, especially to pay regard to pedestrians
and other traffic!
The backup camera system requires an input
voltage of 12 V / DC. Cannot be operated via
24 V / DC!
Attention: risk of property and personal
damage!