Installing The Monitor - AEG RC 3.5 Notice D'utilisation

Step 8: Installing the transmitter
Secure the transmitter with a suitable fastener,
e.g. two cable ties. Be sure there are no
electrical loads in the direct vicinity of the
transmitter to avoid impairing the transmission.
Now secure the cables for the camera and
transmitter run in the void of the trunk with cable
ties . The cables run may not interfere with the
4
vehicle's functionality!
Step 9:Check the transmitter power
supply cable
First engage the hand brake and be sure the
vehicle is not shifted into gear. Vehicles with
automatic transmission must be in "P" for parking
lock. Turn the ignition to II but do not start the
engine! Push the button
monitor. If the transmitter is correctly connected, a
signal will now be transmitted to the monitor when
putting the car into reverse and the monitor will
display the camera's viewing range.
If no image is displayed on the monitor, you can
further check the camera power supply with the
hand brake engaged, ignition turned (II) and the
vehicle in reverse with a simple test. Do not start
the engine! Completely cover the camera with
both palms cupped to darken the camera
surroundings and activate the night vision sensor.
Leave a slight opening between your thumbs and
look into your palms. If the camera is active, all 7
LEDs around the camera will light up red. If the
LEDs do not light up, check the camera's cable
and terminal connections. Also see item 4.7 on
page 25.
( ) to power on the
12

4.2 Installing the monitor

▪ Insert the square monitor socket on the monitor
arm into the designated notch at the back
10
of the monitor. Now slide the monitor bracket
upward until it catches (see image 12).
▪ Open the locknut and adjust the monitor to the
desired viewing angle. Now tighten the locknut
to secure the monitor.
▪ Clean the area of the windshield where you
would like to attach the suction cup base. Now
press the suction cup base onto the windshield
and move the locking lever toward the suction
cup base.
▪ Now plug the monitor cable
cle's outlet (12 V). Place the monitor cable so
as not to impact or jeopardize the safety of the
vehicle and its passengers.
Locking
lever
Locking screw
Image 12
Caution! The location of the monitor
may not impair the visibility of the
driver! Further, do not impair the func-
tionality and operation of equipment, control units
and systems inside the vehicle. Follow applicable
laws and safety regulations for vehicles!
GB 23
into the vehi-
2
Monitor
swivels
Monitor locking
lever