Technical Data; Before Using The Equipment; Operation; Continuous Operation - EINHELL TE-DY 18 Li Mode D'emploi D'origine

4. Technical data

Motor power supply: .............................18 V
Idling speed: ........................... 0-4000 rpm (min
Clockwise/counter-clockwise: ........................yes
Bit holder: ....................................¼ in. (6.35 mm)
Weight (Tool Only): .......................... 2.2 lbs (1 kg)
The maximum screw diameter indicates the
maximum diameter of the screw that can be
screwed into wood. The screw diameter can vary
depending on the type of wood.
Wear ear-muff s.
The impact of noise can cause damage to
hearing.
Reduce noise generation and vibration to a
minimum!
•
Use only equipment that is in perfect
condition.
•
Maintain and clean the equipment regularly.
•
Adapt your way of working to the equipment.
•
Do not overload the equipment.
•
Have the equipment checked if necessary.
•
Switch off the equipment when not in use.
•
Wear gloves.
CAUTION!
Residual risks
Even if you use this electric power tool in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear
protection is applied.
3. Health damage caused by hand-arm
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.
Limit the operating time.
All stages of the operating cycle must be
considered (for example, times in which the
electric tools are switched off and times in which
the tool is switched on but operates without load).
Anl_TE_DY_18_Li_USA_SPK7.indb 12 Anl_TE_DY_18_Li_USA_SPK7.indb 12
EN

5. Before using the equipment

Be sure to read the following information before
you put the cordless screwdriver into operation:
)
-1
1. Charge the battery pack with the charger
supplied. An empty battery pack requires
a charging period of approximately 0.5 to 1
hour.
2. Only ever use sharp drill bits and screwdriver
bits which are suitable for the purpose and in
faultless condition.
3. Always check for concealed electric cables
and gas and water pipes when drilling and
screwdriving in walls.
Note!
The screwdriver is equipped with a jaw clutch.
The spindle will only start to rotate once the screw
is pushed into the workpiece.

6. Operation

6.1 Changeover switch (Fig. 2/Item 3)
The slide switch above the On/Off switch is for
setting the direction of rotation of the cordless
screw gun and for preventing the cordless screw
gun from being switched on inadvertently. You can
select between clockwise and counter-clockwise
rotation. To avoid causing damage to the gearing,
the direction of rotation must only be changed
when the equipment is at a standstill. When the
slide switch is in the middle position, the On/Off
switch is blocked.
6.2 On/Off switch (Fig. 2/Item 4)
Infi nitely variable speed control is possible with
the On/Off switch. The further you push the
switch, the higher the speed of the cordless
screw gun.
Switching on:
Press the On/Off switch (4)

Continuous operation:

Secure the ON/OFF switch (4) with the ON lock
(5).
Switching off :
Press the On/Off switch (4) briefl y or let go.
- 12 -
16.12.2019 15:37:39 16.12.2019 15:37:39