Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
CONTROL PANEL
Indicator light illuminates to signify the cooling mode is currently
in operation.
Control the interior light ON/OFF. (If you press this button, the
inner light is not controlled by the reed switch, and is continu-
ously lit).
To turn appliance on/off (press and hold this button for approxi-
mately 3 seconds).
Adjacent indicator light denotes which scale of temperature is
°C / °F
being displayed.
Window (5): For viewing the temperature of the upper zone.
Window (6): For viewing the temperature of the lower zone.
Button: Used to set the temperature in the upper zone.
Button: Used to set the temperature in the lower zone.
Setting the Temperature Controls
When you plug in your wine cooler for the fi rst time the temperature will automatically be set to 12°C (54°F) in the upper
zone and to 7°C (45°F) in the lower zone. The default setting is °F.
•
The temperature can be set as low as 4°C (39°F) or as high as 18°C (64°F) to suit your specifi c storage require-
ments. Each depression of the
aforementioned range.
•
To switch the display between °F and °C, depress the
FUNCTION INSTRUCTION
Door Ajar Alarm Function
•
If the door is not closed completely the alarm will sound after 5 minutes. Please close the door completely to avoid the
loss of cold air.
Temperature Memory Function
•
If power is lost the set temperature will be saved by the unit. Once the power resumes the unit will return to the same
set temperature.
Temperature Alarm Function
•
If the inner temperature is higher than 23°C (73°F), "HI" is shown on the display panel and the alarm will sound after
one hour. It is to inform you that the inner temperature is too high, please refer to our troubleshooting section.
•
If the inner temperature is lower than 0°C (32°F), "LO" is shown on the display panel and the alarm will sound and the
malfunction indicator light will appear at the same time. Note: If this indicator appears, remove any wine from the unit.
If too many bottles/cans are put in at once or the door has not been closed tightly, the unit will display the "HI" signal in the
display panel. This is normal, please wait 5 minutes after you close the door and "HI" will disappear.
It is normal that the cabinet shows "HI" or "LO" from time to time. If it occurs frequently or lasts for a long time, you can
restart the unit by unplugging it. If the problem occurs once again after restart, please contact customer service.
or
button will allow you to adjust the temperature in 1° increments within the
and
6
°
°
simultaneously for approximately 3-5 seconds.
°
°
6
7
Publicité
Table des Matières
