Mounting Instructions - DURAVIT Cape Cod 7X0330 Notice De Montage

Important information
Mounting instructions information
These mounting instructions come as part of the Duravit
whirltub and should be read carefully prior to installation.
Explanation of the key words and symbols
Indicates a hazardous situation which,
DANGER
if not avoided, will result in death or
serious injury.
Is used to address practices not related
NOTICE
to physical injury.
Link to the Electrical installation section
Link to the mounting information in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and leak-tightness
Indication of the temperature
Control unit
(Number depends on the whirl system)
Target readership and qualifications
The whirltub must only be installed by trained plumbing
engineers. The electrical installation should only be carried
out by qualified electricians.
Risk of product and/or property
NOTICE
damage!
> Observe the local installation regulations and any
country-specific standards at all times.
Safety instructions
DANGER
Risk of fatal electric shock!
> Do NOT remove any whirltub components.
6
WH_M_DuraSolid_FST/17.05.6

Mounting instructions

Please read pre-installation information sheets prior to
the installation. These are available to download on the
Internet at www.pro.duravit.com.
6
Positioning the installation aids (Diagram 6)
The whirltub drain is not located in the centre.
> Observe the dimensions from diagram 5 for
the positioning of the installation aids.
7
Tilting the whirltub (Diagram 7)
NOTICE
Damage due to careless tilting!
> Tilt the whirltub carefully to the side on a clean
surface (cardboard).
15
Checking the whirl system (Diagram 15)
> Switch on the whirl system for 10 minutes:
Run this through once completely in the case of
circuits with different levels of intensity.
> Leave the water in the whirltub and wait 10
minutes.
> Check to make sure that it is leak-tight.
> If adjustments are required, repeat the check.
19
Using silicone without acetic acid (Diagram 19)
> Use alkoxy-based silicone.