Table des Matières
Publicité
5.0 AT Command Line Interface
La description
Obtenir définir la configuration / pare-feu général
Exemple
Commander:
AT+MFGEN=6,0<enter>
Réponse:
OK
La description
Obtenir la configuration / Set pare-feu DMZ
Exemple
Commander:
AT+MFDMZ=0,0<enter>
Réponse:
OK
© Microhard 2016
Syntaxe de la commande
AT+MFGEN[=<Config>[,<Mode>]]
Paramètres
Config: 0 - WAN Remote Management
1 - WAN Request
2 - LAN to WAN Access Control
3 - Anti-Spoof
4 - Packet Normalization
5 - Carrier Remote Management
6 - Carrier Request
7 - LAN to Carrier Access Control
Mode: 0 - Disable (Block)
1 - Enable (Allow)
Syntaxe de la commande
AT+MFDMZ[=<DMZ Source>[,<DMZ Mode>
[,<DMZ Server IP>,<Exception Port>]]]
Paramètres
DMZ Source: 0 - WAN
1 - Carrier
DMZ Mode: 0 - Disable
1 - Enable
DMZ Server IP: Valid IP address
Exception Port: 0 - 65535
AT+MFGEN
AT+MFDMZ
181
Publicité
Table des Matières
