EVVA e-primo air Guide D'utilisation page 28

Electronic cylinder
Creating delete keys
1 Start programming mode.
2 Hold the copy key briefly at the reader.
The light ring will blink red/green (secondary colour).
Ü
3 Hold the programming or user key, for which a delete
key is to be created, briefly at the reader within 5 seconds.
A high-pitched tone will be emitted, the light ring briefly
Ü
illuminates green.
4 Hold the delete key briefly at the reader within 5 seconds.
A high-pitched tone will be emitted, the light ring will
Ü
illuminate green. The delete key for the programming or
user key is now created.
You can create multiple delete keys, one after the other,
by repeating steps 3 and 4.
5 Terminate the programming mode by stopping the
copying medium or waiting for the programming mode to
terminate automatically.
Notice: You should mark all delete keys appropri-
ately for their corresponding keys so that when a
delete key is needed the correct card is available for
28
deleting. Delete keys should be safeguarded securely
and separately from programming and user keys.
Please note that delete keys can only be assigned
once to a programming or user key.
Deleting media
Deleting a lost user key
1 Start programming mode.
2 Hold the delete key for the lost user key briefly at the
reader.
A descending sequence of tones will be emitted, the
Ü
light ring illuminates red/green (secondary colour) then
red. The lost user key is deleted from the cylinder's
memory.
3 Terminate programming mode.
If the delete key is held at the reader during normal ope-
ration, the e-primo cylinder will indicate whether the lost
user key is still valid (green) or not (red).
Deleting a user key which is on-hand
1 Start programming mode.
2 Hold the user key to be deleted (or multiple keys) briefly
at the reader.
A descending sequence of tones will be emitted, the
Ü
light ring illuminates red/green (secondary colour) then
red. The user key is deleted from the cylinder's memory.
3 Terminate programming mode.
Deleting a lost programming key,
assigning a new programming key
1 Start programming mode by holding the delete key for
the lost programming key at the reader.
2 Hold the new programming key briefly at the reader
within 5 seconds.
An ascending sequence of tones will be emitted, the
Ü
light ring illuminates red/green (secondary colour) then
green. The new programming key is now assigned and
the old programming key is deleted from the memory.
If no new programming key is held at the reader within
5 seconds, the original programming key remains stored in