EVVA e-primo air Guide D'utilisation page 27

Operation
Commissioning the e-primo cylinder
The e-primo cylinder is not programmed to media when
delivered.
Assigning media
Assigning the programming key
Hold the programming key briefly at the reader.
l
A sequence of high-pitch tones will be emitted, the light
Ü
ring blinks green. The e-primo cylinder now recognises
this medium as its programming key.
Notice: Please note that it may not be possible to
open the door again after it is closed because the
outside thumb turn will rotate passively, i.e. without
engaging. The e-primo cylinder can only be operated
after assignment of a programming key and a user
key.
Assignment of user keys; programming mode
1 First hold the programming key briefly at the reader.
A sequence of low and high tones will be emitted, the
Ü
light ring blinks red/green (secondary colour) then green.
The e-primo cylinder is now in its programming mode
for 7 seconds.
2 Hold the user key you want to train into the e-primo
cylinder briefly at the reader within 7 seconds.
An ascending sequence of tones will be emitted, the
Ü
light ring illuminates red/green (secondary colour) then
green. The e-primo cylinder now recognises this user key
as valid for locking and unlocking the e-primo cylinder.
You can also assign several user keys, one after the other,
by holding each of them at the reader within 7 seconds.
3 Terminate programming mode by holding the program-
ming key briefly at the reader or waiting for programming
mode to terminate automatically.
A descending sequence of tones will be emitted, the
Ü
light ring illuminates red/green (secondary colour) then
red.
1
2
27