EVVA e-primo air Guide D'utilisation page 24

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
Electronic cylinder
Installing the e-primo cylinder
Please note that it may not be possible to open the door
again after it is closed because the outside thumb turn will
rotate passively, i.e. without engaging. After installation –
but before closing the door – insert a battery (see "Battery
insertion/replacement"), program the e-primo cylinder and
test its functionality. The e-primo cylinder can now only be
opened with a valid identification medium.
Should problems arise during installation, please contact
your dealer or visit our website on the Internet at
www.evva.com/e-primo
24
1 Loosen (turn clockwise) the outside thumb turn's fixing
screw with the special ZTOOL1 Allen wrench and pull it off.
2 Rotate the outside thumb turn such that the outer loca-
ting screw is in the area of the cylinder profile.
3 Push the e-primo cylinder by hand, from inside to out-
side, through the escutcheon and the mortise lock (loosen
the escutcheon's fastening screws if necessary).
4 Fasten the e-primo cylinder in the mortise lock with the
cylinder fixing screw. The cylinder fixing screw should be
tightened down to a torque of 2 Nm (now also re-tighten
the escutcheon's fastening screws if necessary). Place the
gasket into the groove.
Notice: The specified IP rating is only achieved when
the gasket is in place.
5 Carefully push the outside thumb turn cover to its limit
onto the e-primo cylinder. The outer locating screw must
be engaged in the guide groove. Fasten the outside thumb
turn by carefully screwing in (turn counter-clockwise) its
screw with the special ZTOOL1 Allen wrench.
Important: Please assign a programming key and a
user key to the cylinder and make sure a functional
battery is inserted before closing the door!
Important: When using an e-primo with extended
knob sleeve, it should be noted that the outer anti-
twist protection may need to be removed for instal-
lation in the core drawing protection fittings.
Technical problems or malfunctions may occur when
the anti-twist protection is not used.

Publicité

Table des Matières
loading

Produits Connexes pour EVVA e-primo air

Ce manuel est également adapté pour:

E-primo ibuttonE-primo

Table des Matières