Led And Function - Vivobike VM26 Manuel D'instructions

(Fig. 4.3)

5. LED and Function

5.0 On / Off: Press the
5.1 6KM/H
Long press the
the start of the race. After the motor starts working and the bike running, you
could easily pedal and release the button.
5.2 Power display on handlebar panel:
Under normal state, turn on the power supply, the four LED lights will be displayed from low to high power
levels. When all LED lights are bright, this condition indicates that the electricity is full. If the last light has
been flashing, this is a warning, should be charged immediately before riding the battery.
4 LED light on: power is 100%
3 LED light on: power is 70%
2 LED light on: power is 50%
1 LED light on: power is 25%
1 LED light is on and flashing: power will be empty, the battery need to be charged immediately.
5.3 Select assistance level on handlebar panel:
When the power is on, you can shift to 3 assistance levels, low middle and high. Press the button "+" and "-",
to shift the assistance level (Low middle and high). Here is the way how to set the assistance level:
✓ When the power is on, the "middle" LED is on which means the power-assistance is in the 2 nd grade. Then
you can press the "+" and "-" buttons to choose the LOW, MID and HIGH.
✓ For each level, you can also select an intermediate level of support by always using the "+" or "-" buttons.
(Fig. 4.4)
button to turn the LED display on and off.
button to use the "assisted start" function to facilitate
(Fig. 4.5)
(Fig. 5)
24/76