Inserting / Replacing Batteries - Romus RLM-60 Mode D'emploi

Keyboard _ See Picture A
1 ON / Single measure / Continuous measure
2 Area / Volume measure
3 Pythagorean measure
4 Plus / Timer
5 Minus / Units
6 Reference / Illumination
7 Clear / OFF

Inserting / Replacing Batteries

Remove the battery cover, insert the battery correctly. Close the battery compartment.
Replace the battery when this symbol
• Only use alkaline batteries.
• Batteries should be removed in case of danger of corrosion, if the device will not be used for a
long time.
Press this key until the desired unit is displayed.
Optional units:
LENGTH
0.000 m
0.00 m
0.00 ft
0' 0'' 1/16
0 1/16 in
Device and laser are switched on to wait to measure.
Holding down this key
automatically after 3 minutes of inactivity i.e. no key is pressed within that interval.
www.romusworld.com
Overview
Inserting / Replacing Batteries
constantly blinks in the display.
Selecting Units
AREA
0.00 m² ²
0.00 m²
0.00 ft²
0.00 ft²
0.00 ft²
Operation
Switching on/off
for 2 seconds to switch the device off, the device also switches off
LASER DISTANCE METRE RLM-60
Display _ See Picture B
1 Laser ON
2 Reference (front/rear)
3 Area /Volume/ Pythagorean
4 Hardware error
5 Battery display
6 Units with exponents ( 2/3 )
7 Auxiliary Display 2 (e.g. intermediate values)
8 Auxiliary Display 1
9 Main display
VOLUME
0.000 m³ ³
0.00 m³
0.00 ft³
0.00 ft³
0.00 ft³
www.romus.org
LASER MÈTRE RLM-60
RÉF. 93256
9