Inserting / Replacing Batteries - Romus RLM-40 Mode D'emploi

Congratulations on your purchase of RLM-40 distance meter.
Keyboard _ See Picture A
1 ON / Single measure / Continuous measure
2 Area / Volume measure
3 Pythagorean measure
4 Plus / Timer
5 Minus / Units
6 Reference / Illumination
7 Clear / OFF
Remove the battery cover, insert the battery correctly. Close the battery compartment.
Replace the battery when this symbol
• Only use alkaline batteries.
• Batteries should be removed in case of danger of corrosion, if the device will not be used for a
long time.
Press this key until the desired unit is displayed.
Optional units:
LENGTH
0.000 m
0.00 m
0.00 ft
0' 0'' 1/16
0 1/16 in
Device and laser are switched on to wait to measure.
Holding down this key
automatically after 3 minutes of inactivity i.e. no key is pressed within that interval.
www.romus.fr
Les règles de sécurité et les instructions ainsi que le manuel d'utilisation
doivent être lues attentivement avant la mise en service.
Overview

Inserting / Replacing Batteries

Inserting / Replacing Batteries
Selecting Units
AREA
0.00 m² ²
0.00 m²
0.00 ft²
0.00 ft²
0.00 ft²
Operation
Switching on/off
for 2 seconds to switch the device off, the device also switches off
LASER DISTANCE METRE RLM-40
Display _ See Picture B
1 Laser ON
2 Reference (front/rear)
3 Area /Volume/ Pythagorean
4 Hardware error
5 Battery display
6 Units with exponents ( 2/3 )
7 Auxiliary Display 2 (e.g. intermediate values)
8 Auxiliary Display 1
9 Main display
constantly blinks in the display.
VOLUME
0.000 m³ ³
0.00 m³
0.00 ft³
0.00 ft³
0.00 ft³
LASER MÈTRE RLM-40
RÉF. 93256
www.romus.org
8