Romus RLM-60 Mode D'emploi page 11

Press this key briefly. This symbol
measurement and then the volume value will be displayed in the main display area and the third line
measured value is displayed in the auxiliary area.
Pythagorean measurement is used in the condition that the objective needing to be measured is cove-
red or has no effective reflecting surface and can't be measured directly. The accurate measured result
can be got only when the laser beam and measured goal are at the right angle.
Press this key briefly, this symbol
prompts, press
operation then the instrument will automatically realize Pythagorean operation, the result is displayed
in the main display area.
•When measuring in Pythagorean measurement mode, right-angle edge length must be less than the
length of the hypotenuse, otherwise the equipment will report mention information.
• Under the Pythagorean measurement mode, make sure to start the measurement from the same
starting point. In hypotenuse - right angle edge model, it is also necessary to ensure that right-angle
side is perpendicular to the measured surface.
In the course of using the instruments, information as below may be displayed on the screen:
INFO CAUSE
204 Data overflow
205 measurement range transfinite Use the meter in distance
252 Temperature too high
253 Temperature too low
255 Received signal too weak
256 Received signal too strong
257 Pythagorean measurement
Violation
258 Initialization error
ERROR Cause
Hardware error
www.romusworld.com
Volume
is displayed. Press this key
Pythagorean calculation
is displayed in the screen. According to the on-screen
to take right angle edge - right angle, or bevel edge - right angle edge
Appendix
Display Notices
LASER MÈTRE RLM-60
LASER DISTANCE METRE RLM-60
to take the three lines
CORRECTION
Repeat steps
allowed
Let device cool down
Warm device up
Measure target point with
stronger reflectance
Measure target point with wea-
ker reflectance
Re-measure and ensure the
hypotenuse is greater than
right angle edge
reboot
Correction
If the signal still appears after
repeatedly switching on/off the
equipment, please contact your
dealer.
www.romus.org
RÉF. 93256
11