Safety Instructions - BST PWA320 Manuel D'utilisation

PWA320
8)

SAFETY INSTRUCTIONS

Read all safety instructions before operating PWA 320
Install equipment as follow condition.
- Install in a flat place, not bending or curved.
- Do not install near water and moisture.
- Place power amplifier away from heat source, such as radiators or other heat source.
Keep in mind the following when connecting amplifiers
- Read the owner manual before connecting the amplifier
- Connect each connection of the amplifier perfectly. If not, it maybe cause hum, damage, electric shock in case of misconnection.
- To prevent electric shocks, do not open top cover.
- Connect the power cord with safety after check of AC power
9) BATTERIES CHARGING
- Connect the AC cable in the AC /DC adapter then connect it to DC input on PWA 320. The batteries leds lights on green showing a
good operating of the charge system. If the led lights in red, the batteries are empty.
- The charge automatically stops when batteries are full charged. Stay the speaker in charge during 4 to 6 hours or a good charge. For
a full charge, keep it in charge during 15 hours..
NOTE : Even if you do not often use the PWA 320, you must charge batteries at least once a month, otherwise you may destroy
the batteries
10) SPECFICATIONS
PWA 320 :
- Frequencies band : UHF 863-865MHz
- Stability : +/- 0.005%.
- Modulation : +/-20KHz
- Frequency response : 70Hz – 18KHz (+/-3dB)
- Distortion : <0.05%
- Power : 300W
- Charging time : 6-12 heures max
- Operating time : 4-6 heures max
- Dimensions : 340x340x490mm
- Weight : 14,3Kg
Handheld mic :
- Built-in antenna
- Batteries : 2x 1.5V AA
- Operating time : 8 hours max
- RF power : 10mW
- Dimensions : 250x54mm
- Weight : 270g
Belt transmitter :
- Mic impedance : 470Kohms
- Batteries : 2x 1.5V AA
- Operating time : 10 heures max
- Dimensions : 85x65x24mm
- Weight : 85g
CD player :
- Compatible DVD / MP3 / CD / CR-R / CD-RW
- Frequency response: 20Hz – 20KHz
- S/N ratio : >80dB
WARRANTY CONDITIONS
BST equipment is covered by a 2-year warranty on parts and labour except for built-in batteries and mic battery.
The following rules apply from the day the equipment leaves the factory:
The date on the invoice is considered to be the date the warranty begins.
Only companies approved by BST are allowed to work on the equipment. Warranty becomes void when other service technicians open the
equipment.
During warranty period, defective equipment must be sent by pre-paid mail in the original box.
BST will return the goods by pre-paid mail during the first year of warranty; thereafter the mailing cost is to be paid by the recipient
Potentiometers have a limited lifetime and are not covered by the manufacturer for more than normal use.
For all service enquiries, refer to your local distributor, as he is best able to help you.
© Copyright LOTRONIC 2015
WWW.BSTDJ.COM
Page 17