Control Panel Description - BST PWA320 Manuel D'utilisation

PWA320
4)

CONTROL PANEL DESCRIPTION

1. FUSE
The fuse protects the speaker against surges. If the enclosure does not light, check the fuse. If that is burnt or broken, replace it by one of
the same size and value.
2. EXTERNAL SPEAKER OUTPUT
This output allows you to connect a passive additional speaker
3. PWA BROADCAST VOLUME CONTROL / ON-OFF BUTTON
Press this button to turn on or turn off the PWA broadcast module. It is also used to adjust the volume of this
4. TX / RX SELECTOR
This selector allows to choose the operating mode of the PWA-BROADCAST module (in OPTION) Transmitter (TX) or receiver (RX)
If you want to use the speaker in master with a PWA-BROADCAST-TX module ( the signal of this enclosure will be sent to another
PWA320), put the switch on TX. On the other hand, if you want to use this speaker as slave with a PWA-BROADCAST-RX module
you will receive the audio signal coming from a master PWA320, set the selector on RX
5. LINK INPUT LEVEL CONTROL BUTTON
This setting allows to adjust the level of the signal input link. This setting is active only when the speaker is positioned in slave mode
© Copyright LOTRONIC 2015
WWW.BSTDJ.COM
module.
Page 13