BST PWA320 Manuel D'utilisation page 14

PWA320
6. LINK CHANNEL OPERATING MODE BUTTON
this selector allows to choose the mode of operation of the speaker when you use several PWA320 in wired connection. master or slave . if
you want to use the speaker in master (that is, the signal of this enclosure will be sent to other PWA320) turn the switch on master position.
On the other hand, if you want to use this speaker as slave (that is, you will receive the audio signal coming from a master PWA320, slide
the switch to slave position )
7. LINK OUTPUT
Connect this output to the input of another speaker PWA320 input LINK
8. LINK INPUT
Connect this input to the output LINK of another speaker PWA320. Turn the knob (6) to the SLAVE position
9. ECHO LEVEL CONTROL
This setting allows to adjust the level of echo the signal coming from the assigned microphones (wired or
10. MIC TONE CONTROL
Adjusts the tone (more higher or lower) of the microphone signal (wired or wireless)
11. MIC LEVEL CONTROL
Allows you to adjust the level of the MIC input signal
12. MIC INPUT
Connect a microphone to this input. COMBO XLR - Jack 6.35
13. LINE INPUT LEVEL CONTROL
Allows to adjust the input signal from the device connected to the line input input ( cinch )
14. LEFT LINE INPUT
Connect the left channel output of an audio source line level such as a CD player, DVD player, smartphone, tablet or MP3 player on this
input.
15. RIGHT LINE INPUT
Connect the right channel output of an audio source line level such as a CD player, DVD player, smartphone, tablet or MP3 player on this
input.
16. VOICE PRIORITY SELECTOR
This switch is used to enable or disable the VOICE PRIORITY function. When this function is activated, the volume of the audio sources
decreased when someone speaks into a microphone (wired or wireless). The level returns to normal after a few seconds when no one uses
the microphones.
17. MAIN LOW TONE CONTROL
Allows you to adjust the level of low frequencies of the master signal
18. MAIN HIGH TONE CONTROL
Allows you to adjust the level of high frequencies of the master signal
19. MASTER LEVEL CONTROL
Used to adjust the main level of the speaker. This setting is enable only when the speaker works in master mode. In slave, the level is
adjusted by the link button
© Copyright LOTRONIC 2015
WWW.BSTDJ.COM
wireless).
Page 14