Mains Connection; Putting Into Operation And Use - Conrad Electronic M.A.R.L.I.S. 2.0 MkII Notice D'emploi

10. Mains Connection

The mains outlets to which the PA system is connected must be easily accessible to quickly
separate the device from the mains voltage in case of an error.
The PA system and all connected devices must be turned off when connecting the voltage
supply.
Ensure that all the electrical connections and connection cables between the different devices
and any extension cables comply with the regulations and comply with the operating instructions.
• Insert the non-heating appliance plug of the mains cable into the mains connection (9).
• Plug the power plug of the power supply cable into a wall socket.
• The POWER switch (8) is used to switch the PA system on and off.
Position "O": Device is switched off.
Position "I": Device is turned on.
When the device is switched on, the POWER indicator (4) lights up.

11. Putting into Operation and Use

Start operating the device only after you have familiarized yourself with the functions and this
operating manual. Check again that all connections are correct. Do not put the product into
operation if it is damaged.
The PA system should always be the last to be turned on and the first to be turned off. In this
way you prevent any undesired noises (which can typically occur when switching off a mixer)
from damaging the PA system.
Make sure that the connected devices are not overloaded. The playback should not be distorted
under any circumstances. If distorted music signals can be heard although the volume was not
set too high, switch off the PA system immediately and check the connection. If you can find
no errors in the connection, please contact a specialist.
The device may only be operated by persons familiar with the operating instructions. Keep
other persons and children away from the device.
• Turn the controls MAIN LEVEL (1) and SUB LEVEL (3) down completely (to the left).
• Switch on the connected mixer and start the playback. Set to a medium volume on the mixer.
• Turn the PA system on with the POWER switch (8).
• Adjust the volume on the mixer to about 75% of the maximum volume or to the maximum undistorted level (visible
on devices with recording level displays and the "0 dB" marking).
27