Connecting The Signal Inputs - Conrad Electronic M.A.R.L.I.S. 2.0 MkII Notice D'emploi

8. Connecting the signal inputs

The PA set is equipped with symmetrical XLR inputs and with unsymmetrical cinch connections. The type of
connection does not affect operation. However, make sure you always use only one type of connection.
When connecting the signal inputs, make sure that the connection cables are not pinched or
damaged by sharp edges.
The inputs may be connected only to low-level audio outputs of audio devices.
The PA system and the device it is connected to must both be switched off during connection.
When connecting the cinch or XLR inputs, only use suitably shielded cinch or XLR connection
cables. Using incorrect cables may lead to interference.
To avoid distortion or mismatching that may damage the PA system, only audio devices with
a cinch output may be connected to the cinch inputs of the device. Only devices with XLR
outputs may be connected to the XLR inputs.
For this, observe also the connection values in the section "Technical Data".
• Connect the INPUT LEFT/RIGHT cinch connections (5) or INPUT LEFT/RIGHT XLR connections (6) with the pre-
amplifier outputs of the upstream audio device (e.g. mixer).
• Connect the socket INPUT RIGHT with the right pre-amplifier output and the socket INPUT LEFT with the left
pre-amplifier output.
R L
MAIN
LEVEL
0°
SUB
PHASE
M.A.R.L.I.S.
180°
SUBWOOFER
SUB
SATELLITE
LEVEL
SYSTEM
800 WATT
ENGINEERED
POWER
IN GERMANY
INPUT RIGHT INPUT LEFT
SAT POWER OUT SAT POWER OUT
RIGHT LEFT
FUSE T 3.15A
REPLACE AS
MARKED
I
O
220-240V AC 50-60HZ
POWER
MAX 600VA / AC ~
25