Spare Parts; Waste Disposal And Environmental Protection - IKRA GMEB 800 S Gartenmeister Mode D'emploi

Troubleshooting
Problem
Motor does not start
Abnormal noises
Abnormal vibrations
Poor scarification results

Spare parts

Please contact our service department if you need
accessories or spare parts.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to
persons or damage to the machine.
The following information should be provided when
ordering spare parts:
• Type of machine
• Item number of the machine

Waste disposal and environmental protection

Dispose of the machine properly after it is worn out. Dis-
connect the mains cable in order to prevent misuse. Do
not dispose of the machine with the household waste. In
the interest of environmental protection, take it to a col-
lection point for electric machines. Your responsible local
authority can provide you with addresses and operating
GB | Operating Instructions
Possible causes
No electricity
Defective cable
Defective safety switch/plug
combination
Overheat protection actived
Blade is jammed
Lubrication running out
Loose bolts, nuts or other securing
components
Blades damaged or worn
Working depth too large
Working depth too small
Worn blades
times. Also take the packaging materials and worn out
accessories to the appropriate collection points.
In accordance with European Directive 2012/19/EC on
waste electrical and electronic equipment and its im-
plementation in national law, waste electric tools must
be collected separately for environmentally-compatible
re-use.
Recycling alternative to the return invitation:
Instead of returning the electric equipment, the owner is
alternatively obligated to take part in the proper recycling
in the case of relinquishment of ownership. The waste
equipment can also be taken to a collection facility which
disposes of it in the sense of the national recycling man-
agement and waste acts. This does not pertain to the ac-
cessory parts and auxiliary equipment without electrical
components accompanying the waste equipment.
GB-6
Remedy
Check mains connection
Check cable, plug in, replace if
required, or have it repaired by a
qualified person
Arrange for repair in a specialist
workshop
1. Working depth too large, set to
the shorterdepth
2. Blades blocked, remover the
blockage
3. Soil too hard, select correct work
depth andforwards and backwards
several times whileslowly down the
operation speed.wait till the motor
cool down for around 15 minutes
before rework
Switch off wait till complete stop.
Remove the objects
Arrange for repair in a specialist
workshop
Tighten all components, contact
specialist workshop
Replace or have it checked by an
specialist workshop
Set to correct working depth
Set to correct working depth
Replace or have it checked by an
specialist workshop
Only for EU countries
Do not discard electric tools in the household
waste!