Technical Data - Matrix X-One 20V Manuel D'utilisation

Important. Set the changeover switch (3) to its
centre position whenever you carry out any work
(for example changing the tool, maintenance work,
etc.) on the cordless screwdriver.
• The cordless screwdriver is fitted with a
quickaction chuck (9) with an automatic spindle
stop.
• Open the chuck (9). The chuck opening (a) must
be large enough to hold the tool (drill bit or
screwdriver bit).
• Select the suitable tool. Push the tool as far as
possible into the chuck opening (a).
• Tighten the chuck (9) and then check that the
tool is secure.
8.9 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating
instructions, to suit the size of screw.
Work for metal, wood: Rotate the torque selector
to the drill icon, then this machine can work for
metal and wood;
Work for stone: Rotate the torque selector to the
hammer icon, then machine can for work for stone.

9. Technical data

Voltage supply:
No-load speed:
Torque settings:
Forward and reverse rotation:
Chuck clamping width:
Battery charging voltage:
Battery charging current:
Mains voltage for charger:
220-240V AC,50Hz, 50W
Charging time:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 62841.
L : sound pressure level 86 dB(A)
pA
K : uncertainty 5 dB(A)
pA
L : sound power level 97 dB(A)
WA
K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
62841.
Drilling in metal
Vibration emission value a
a
h D
K uncertainty = 1,5 m/s
NOTE: The indicated vibration value has been
determined on the basis of a standardised test
procedure and can be used for comparing different
products. Moreover, this value can be used to
estimate the load on the user caused by vibrations.
The vibration value can be caused by the following
factors which should be taken into consideration
before or during each use of the tool:
- Correct use of the tool
- Impeccable condition of the tool
-Condition of the worked material
- Are the handles and optional vibration handles, if
available, correctly and tightly mounted to the tool
body.
20 V
If your hands feel uncomfortable or the skin colour
0-450/0-1600 rpm
of your hands changes when using the tool,
20+1+1
you must immediately interrupt your work. Take
yes
enough breaks. Failure to take enough breaks may
max. 13 mm
result in the hand-arm vibration syndrome.
21 V
1800 mA
CAUTION!
Depending on the application of the product,
the actual vibration values may deviate from the
1 h
indicated values! Take measures to protect yourself
against vibrations! To this end, you must take the
whole work flow into account, i.e. also the time
when the tool is operated without load, or when
the tool is switched off! Appropriate measures
include the regular maintenance and care of the
19
: uncertainty 5 dB(A)
=9.488 m/s
h,ID
2
=1,190 m/s
2
UK
2
,