Matrix X-One 20V Manuel D'utilisation page 18

an empty battery is approximately 1 hour.
UK
4. The temperature of the battery pack may rise
slightly during the charging operation. This is
normal. If the green LED extinguishes during
charging, the temperature is either above or below
the perfect charging temperature. In this case, pull
the plug of the charger and charge the battery in
an environment in which the temperature is either
warmer or colder.
If the battery pack fails to become charged, please
check
• whether there is voltage at the socket-outlet
• whether there is proper contact at the charging
contacts on the charger.
If the battery still fails to become charged, please
return
• the charger
• the battery pack
to our Customer Service Department.
To ensure that the battery pack provides long
service you should take care to recharge it
promptly.
You must recharge the battery pack when you
notice that the power of the cordless screwdriver
drops.
Never fully discharge the battery pack. This will
cause the battery pack to develop a defect.
8.2 Torque setting (Fig. 4 / Item 1)
The cordless drill is fitted with a
mechanical torque selector.
The torque for a specific size of screw is selected
with the set-collar (1). The correct torque
depends on several factors:
· on the type and hardness of material in question
· on the type and length screws used
· on the requirements needing to be met by the
screwed joint.
The clutch disengages with a grating sound to
indicate when the set torque is reached.
Important! The tool must be at a standstill when
you set the torque with the setting ring.
8.3 Drilling (Fig. 5 / Item 1)
For drilling purposes, move the set-collar to the
last step „Drill".
The maximum torque is available in drilling mode.
If you turn the torque selector to the hammer
symbol, this battery can work as a hammer.
8.4 Forward/Reverse switch (Fig. 5 / Item 3)
With the slide switch above the On/Off switch you
can select the direction of rotation of the
batterypowered drill/screwdriver and secure it
against being switched on accidentally. You can
choose between clockwise and anticlockwise
rotation. To avoid causing damage to the gearing
it is advisable to change the direction of rotation
only when the tool is at a standstill. The On/Off
switch is blocked when the slide switch is in centre
position.
8.5 On/Off switch (Fig. 5 / Item 4)
Infinitely variable speed control is possible with the
On/Off switch. The further you press the switch,
the higher the speed of the battery-powered drill/
screwdriver.
8.6 Changing over from 1st gear to 2nd gear
(Fig. 7/ Item 7)
You can work at a higher or lower speed
depending on the position of the selector switch.
To avoid damaging the gear unit you should only
change over gears when the tool has stopped.
Turn on:
Press and hold the on / off switch to start up the
unit.
Turn off:
To switch off the unit, release the on / off switch.
8.7 Battery capacity indicator (Fig. 6– Item 2)
The 3 LEDs (2) will indicate the status of battery
capacity as soon as you press the button.
8.8 Changing the tool (Fig. 8)
18