Cleaning And Maintenance; Technical Data - Matrix AK 18-SP Traduction De La Notice Originale

Electronic speed control
By pressing the ON/OFF switch (1) you can control
the speed of the drill from 0 to maximum speed.
Direction of rotation
.
Direction switch (2) to the "left" looking from
above: Clockwise, drilling setting/screw-in setting
.
Direction switch to the "right" looking from
above: Anti-clockwise, screw-out setting.
Drilling
.
Set torque setting to
.
Set direction of rotation slider to clockwise
rotation
.
Position bit and slowly increase speed and
drilling pressure.
Screwing
.
Torque setting to 1-16.
.
Set the direction of rotating slider to clockwise.
For removing screws set it to anti-clockwise..
.
Use the appropriate flathead or crosshead bit.

9. Technical Data

Rechargeable battery:
Rotational speed:
Torque setting:
Clockwise/counter-clockwise rotation
Drill chuck span:
Max. torque:
Rechargeable battery charging voltage:
Rechargeable battery charging current: 400 mA.
Charging time:
Charging unit:
Sound and vibration
Sound and vibration values were measured in
accordance with EN60745-1, EN60745-2-1 and
EN60745-2-2.
Sound pressure level L
Sound power level L
Uncertainty K:
Vibration a
Uncertainty K:

10. Cleaning and maintenance

Always pull out the mains power plug before
starting any cleaning work.
10.1 Cleaning
• Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• We recommend that you clean the device
immediately each time you have finished using it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
10.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
18 V/1,2 Ah NiCd
-1
0 –550 min 11. Repairs
16+1stage
Only use accessories and spare parts
0,8-10 mm Ø
recommended by the manufacturer.
10 Nm
If the equipment should fail some day in spite of
24 V
our quality controls and your maintenance, only
have it repaired by an authorized electrician.
3-5 h
220-240 V~50/60 Hz
:
pA
:
WA
:
h,D
60,2 dB(A)
71,2 dB(A)
3 dB(A)
2
0,866 m/s
2
1,5 m/s
25