Before Starting The Equipment - Matrix X-One 20V Manuel D'utilisation

In compliance with applicable European
directives
Class II
The charger is only suitable for indoor
use.
Polarity
Batteries are not belong to litter bin.
There is a legal obligation to return
batteries for proper disposal.
Li-lon
End of life machines contain valuable
materials and therefore they should not
be placed in household waste.
We would ask you to play your part in
protecting resources and help protect
the environment by returning this
machine to a return point (if one is
available) when it reaches the end of its
life.
6. Layout
1. Torque selector
2. Battery capacity indicator
3. Changeover switch
4. ON/OFF switch
5. Li-lon Battery pack
6. Battery charger
7. Selector switch for 1st/2nd gear
8. Pushlock button
9. Chuck
10. Work light

7. Before starting the equipment

Be sure to read the following information before
you use your cordless screwdriver for the first time:
1. Charge the battery pack with the charger
supplied. An empty battery pack requires a
charging period of approximately 1 hour.
2. Only ever use sharp drill bits and screwdriver bits
which are suitable for the purpose and in
faultless condition.
3. Always check for concealed electric cables and
gas and water pipes when drilling and screwing
in walls.
8. Operation
8.1 Charging the battery pack (Fig. 2/3)
1. Remove the battery pack (5) from the handle,
pressing the pushlock buttons (8) downwards to
do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the mains plug of the charger (6)
into the mains socket outlet.
3. Push the battery pack onto the battery charger.
The flashing red LED will come on to indicate
that the battery pack is being charged. When the
charging process is finished, the green LED will be
permanently lit. The time it takes to fully recharge
17
UK