instruction manual
operAtion - general
The appliance is intended only for domestic use, not
for professional use.
1. Hose connection
2. Cable reel-in button
3. Vacuum-cleaner handle
4. On/off switch suction pressure control
5. Rear wheels
6. Dust receptacle
7. Hose
8. Grip with adjustable air opening
9. Dust container lid release button
10. 2-in-1 Attachment
11. Tube
12. Combi nozzle
13. Exhaust filter
14. Dust container release button
operAtion
1. P ush the hose into the hose connection on the
motor unit (see figure 2A). To remove the hose,
push the two buttons and pull it out of the hose
connection.
2. T he power cord has a yellow and red mark (see
figure 2B). Pull out the cord to the yellow mark.
N ever pull out the power cord beyond the red
mark. This could damage the power cord.
3. P ut the plug in the wall socket, and press the
On/Off switch. To switch off the appliance, press
the On/Off switch again (see figure 2C).
4. T he appliance is now ready for use. You can move the vacuum cleaner while you are cleaning by pulling
on the hose grip. You can lift the appliance with the vacuum cleaner's handle (see figure 2E).
5. Y ou can adjust the vacuum suction with the vacuum suction control (see figure 2D). It is advisable to
reduce the vacuum suction when cleaning upholstered furniture and curtains. This will prevent the fabric
from being sucked into the nozzle.
note If so required, you can also reduce the suction quickly by moving the slide on the hose grip.
6. S lide both tubes into each other (see figure 3A).
7. Slide the hose handle into the tube (see figure
3B).
8. P ress the foot button on the nozzle to set the
combi nozzle for use on hard or soft surfaces,
(see figure 3C). For use on hard surfaces, press
the foot button on the combi nozzle to extend
the brushes. Lift the button for use on soft
surfaces.
8
11
6
1
A
19
7
10
3
9
2 14
4
13
5
12
E
C
B
D
B
C