Ayce Z1C-32EH1T Manuel D'utilisation page 36

OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. They should fit with the machine and your purpose.
2. Functions
Fitting and changing tools (Fig.1)
The device is equipped with a SDS-plus attachement system
• Clean tools and grease with a thin layer of machine grease before fitting.
• Pull back fastening sleeve (2) and hold.
• Push and rotate the dust-free tool into the tool holder as far as it will go. The tool
will lock automatically.
• Check that it has locked by pulling the tool.
Removing SDS-plus tool
Pull back fastening sleeve (2), hold and remove the tool.
WARNING
Accessories can be hot after use. Don't touch the tip of accessory by hand!
Please always use protective gloves to remove the accessory.
On/Off switch
Use the On/O switch to start the machine and keep holding it for continuous operation.
To switch the machine o , release the On/O switch
Fig.1
Auxiliary Handle (Fig.2)
CAUTION!
The machine should be used only with both handles.
Do not continue to use an auxiliary handle if it is damaged.
Lossen and turn the auxiliary handle (3) in an ant-clockwise direction. Slip loop onto the
neck of the housing tool and position the handle, then tighten the handle.(Fig. 3)
Depth gauge
Loose the auxiliary handle (3) and place the straight part of the depth gauge (8) in the hole.
Adjust the depth gauge (8) and retighten the auxiliary handle (3).
Dust collection device (Fig.3)
Before carrying out hammer-drilling work, vertically overhead pull dust collecting device
over the drill bit.
|
69 70
Fig.2
Fig.3
GB D