Description Of The Symbols - Ayce Z1C-32EH1T Manuel D'utilisation

DESCRIPTION OF THE SYMBOLS

1. Safety symbols
The use of symbols in this manual is intended to draw your attention to possible risks. The
safety symbols and the explanations that accompany them must be perfectly understood. The
warnings in themselves do not remove the risks and cannot replace correct actions for
preventing accidents.
This symbol, marking a point of safety, indicates a caution,
warning or danger. Ignoring this warning can result in an
accident to yourself or others. To limit the risks of injury,
re or electrocution, always follow the recommendations
indicated.
Before any use, refer to the corresponding section in this
user manual.
These symbols indicates the requirement of wearing ear
protection, eye protection, respirator and gloves when
using the product.
Conform to CE safety standards.
Class II machine – Double insulation
The crossed-out wheeled bin symbol indicates that the item
should be disposed of separately from household waste.
The item should be handed in for recycling in accordance
with local environmental regulations for waste disposal. By
separating a marked item from household waste, you will
help reduce the volume of waste sent to incinerators or
land- ll and minimize any potential negative impact on
human health and the environment.
2. Product symbols
In this manual and/or on the machine the following symbols are used. These represent
important information about the product or instructions on its use.
1500W Rated output
230V~50HZ
Rated voltage
0-800/min
No load speed
SDS plus system
enables easy and
safe bit replacement
5J impact energy
| GB D
67 68
13mm drill capacity
in steel
32mm drill capacity
in concrete
40mm drill capacity
in wood
3m cable with
Swiss plug