Intended Use; Special Safety Instructions; General Safety Warnings For The Tool - Ayce Z1C-32EH1T Manuel D'utilisation

IMPORTANT INFORMATION
At any time and without prior notice Ayce Power tool reserves the right to change and
improve the design and the technical speci cations of this product.

INTENDED USE

The machine is intended for hammer drilling in concrete, brick and stone. It is likewise
suitable for drilling without hammer in wood, metal, ceramic, plastic and chiseling.

SPECIAL SAFETY INSTRUCTIONS

1.Wear ear protectors. Exposure to noise can cause hearing loss.
2.Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3.Hold power tool by insulated gripping surfaces, when performing an operation
where the drilling accessory may contact hidden wiring or its own cord.
Accessory contacting a "live" wire may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
4.Wear dust mask, dust powder can cause personal injury.
5.Always keep the extension cable well away from the workplace.
6.Rotary hammer, tools and accessories shall only be used in the way as stated for
normal use.
7.Always hold the machine with both hands during operation and adopt a safe stance.
8.For outdoor use the machine must be connected to a socket which is connected with a
current surge preventing switch.
9.Dust and splinters must not be removed while the machine is running.
10.When drilling in walls ceiling, or oor, take care to avoid electric cables and gas or
water pipes.
11.Small work-piece must be secured tightly to avoid the turning of work-piece with
drill-bits.
12.Always disconnect the power plug before performing any work on the machine, or
not in use.
13.Only connect the power plug when the machine is OFF. Disconnect the power plug
after use.
14.This device must not be used by people (included children) whose physical capacities,
sensory capacities or mental abilities have been reduced, or by people devoid of
experience or knowledge, except if they have been overseen or if they have got prior
instructions on the use by someone who is in charge of their safety.

GENERAL SAFETY WARNINGS FOR THE TOOL

WARNING
Read all safety warnings and instructions. Failure to follow
all the warnings and instructions may result in electric shock, re and/or serious injury.
SAVE ALL THE WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
The term "power tool" in the warnings refers to your mains operated (corded) power tool or
battery operated (cordless) power tool.
1) Work area safety
a) Keep work area clean and well lit. Cluttered and dark areas invite accidents.
b) Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools create sparks which may ignite the dust
or fumes.
c) Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
2) Electrical safety
a) Power tool plugs must match the outlet. Never modify the plug in any way. Do not
use any adapter plugs with earthed (grounded) power tools. Unmodi ed plugs and
matching outlets will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded surfaces such as pipes, radiators,
ranges and refrigerators. There is an increased risk of electric shock if your body is earthed
or grounded.
c) Do not expose power tools to rain or wet conditions. Water entering a power tool will
increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the
power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric shock.
e) When operating a power tool outdoors, use an extension cord suitable for outdoor
use. Use of a cord suitable for outdoor use reduces the risk of electric shock.
f) If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
63 64 | GB