Hardware Installation - Belkin OmniView PRO 16-Port Guide D'utilisation

F1D116_OSD_AM_man.qxd 4/20/00

Hardware Installation

PLEASE FOLLOW THIS INSTALLATION PROCEDURE EXACTLY. NOT DOING SO MAY
RESULT IN KEYBOARD AND/OR MOUSE ERRORS, OR FAULTY OPERATION.
WARNING:
PRO or the computers, make sure everything is powered off. Plugging and
unplugging cables may cause irreversible damage to your computers and
the OmniView
damage caused.
1.
Set the DIP switches. If you have only one OmniView
bank setting. If the OmniView
another unit, use a unique slave setting. Please refer to the previous section
for more information.
2.
Find a convenient place to put your OmniView
ideal for 19" racks. When mounting to a rack, attach the included brackets to the
sides of the OmniView
computers, OmniView
4:07 PM Page 7
Before attempting to connect anything to the OmniView
PRO. Belkin Components will not be held responsible for
™
™ PRO you are using will be daisy-chained off
DIP SWITCH #
3 4 5 6
ON ON ON ON
OFF ON ON ON
ON OFF ON ON
OFF OFF ON ON
ON ON OFF ON
OFF ON OFF ON
ON OFF OFF ON
OFF OFF OFF ON
ON ON ON OFF
OFF ON ON OFF
ON OFF ON OFF
OFF OFF ON OFF
ON ON OFF OFF
OFF ON OFF OFF
ON OFF OFF OFF
OFF OFF OFF OFF
NOTE: "ON" is down
™ PRO. Take note of the length of your cables so that your
™ PRO, keyboard, mouse, and monitor are distanced properly.
PRO, use the MASTER
™
BANK ADDRESS
BANK 0 MASTER
BANK 1 slave
BANK 2 slave
BANK 3 slave
BANK 4 slave
BANK 5 slave
BANK 6 slave
BANK 7 slave
BANK 8 slave
BANK 9 slave
BANK A slave
BANK B slave
BANK C slave
BANK D slave
BANK E slave
BANK F slave
PRO. Its 19" form factor makes it
™
7
En
™