Safety - Sefa DUPLEX MINI PRO Manuel Utilisateur

Please read the Operating Manual carefully before operating the press.
The press should be operated by a qualified person who is aware of the potential dan-
gers arising from improper use of the equipment. The factory-installed pneumatic,
electrical and mechanical settings programmed by our technicians and the safety fea-
tures must not be altered under any circumstances. SEFA accepts no liability for pro-
blems that may be caused by the machine if such alterations are made.
THIS MACHINE IS DESIGNED FOR USE BY A SINGLE QUALIFIED OPERATOR
a� International symbols
b� Important safety precautions
Personal Protective Equipment (PPE) must be worn (e.g. gloves and
safety glasses).
Do not touch hot parts of the machine during use. Do not place hands
between the platens when the machine is switched on. Make sure the
operator is not exposed to risks of burns, electrocution or other ha-
zards when handling the machine.
Check the machine each day before use. Make sure there is nobody in
the vicinity of the machine before starting work. If the machine mal-
functions, cut the power supply and look for the cause of the problem
(see the Servicing section of this manual).
c� Safety features
No changes must be made to the safety covers and safety systems.
They must be refitted if they are removed for servicing work.
They must be kept in place and in good condition during normal use.
Presses are fitted with safety systems to protect the operator from pinch-point hazards.
The main safety components are:
- Front-mounted button that switches the machine off when pressed.
- Two contact switches are located on top of the upper heat platen.
This system helps safeguard the operator against pinch points and crushing
hazards.
If the system detects an obstacle, it raises the heat platen, immediately shuts off the
swing function and puts the press into safe mode.
To restore the machine to operating mode, press the red area on the «Alarm» page,
position the arm over one of the lower platens and depress the pedal.
Test the emergency shut-off and the safety guard daily. After an emmergency sttop,
make sure there are no other unresolved problems preventing use before restoring
the machine to normal operating mode. Turn the red button to release the emergency
stop. The machine will be reset automatically.
Technical parts documents are supplied with the machine. Please read them before
starting to use your SEFA machine.
www.sefa.fr

SAFETY

OFF
ON
DANGER, WARNING
User guide - SEFA DUPLEX MINI PRO
HOT SURFACE
ELECTROCUTION
HAZARD
7