EIBENSTOCK EMF 150 Notice Originale page 21

Noticeable decreasing work progress and circular sparking are indications of
a blunt diamond cutting disc. Briefly cutting into abrasive material (e. g. lime-
sand brick or the EIBENSTOCK-diamond-sharpening-stone) can re-sharpen
the disc again.
Pre-selection of the Cutting Depth
Fig.2
Changing the Diamond Cutting Discs
Attention!
The Cutting discs, spacer discs and the flange nut might heat up
enormously during operation. You could burn your hands or get cut or
ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Before any work on the tool, disconnect the plug from the mains!
For adjusting the cutting depth open
the locking lever.
By turning the protection cover adjust
the required cutting depth on the
scale and close the locking lever
again.
The locking lever has to be locked
firmly on working always.
21