Publicité
Les langues disponibles
Les langues disponibles
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
ƒ
Always lead the mains and extension cable as well as the extraction
hose to the back away from the machine.
ƒ
Power tools have to be inspected by a specialist in regular intervals.
ƒ
Never carry the machine at its cable.
ƒ
Do not touch rotating parts.
ƒ
Persons under 16 years of age are not allowed to use the tool.
ƒ
During use, the operator and other persons standing nearly have to wear
suitable ear protectors, a dust mask, protection goggles as well as
protective gloves.
ƒ
Make sure that persons in the work space are not endangered by
particles flying around.
ƒ
Keep the handles dry, clean and free of oil and grease.
ƒ
Attention! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
Before starting the machine check the correspondence between voltage and
frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The wall chaser is made in protection class II.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
The tool is equipped with a start-up speed limiter to prevent that swift
automatic circuit breakers are unintentionally triggered.
Recommended minimum cross sections and maximum cable lengths
Mains voltage Cross section in sq. mm
1.5
110V
230V
50 m
Electrical Connection
-
2.5
40 m
80 m
19
Publicité
