JVC KD-AR959BS Manuel D'instructions page 30

Wiring connection (for KD-R950BT / KD-AR855BT / KD-R850BT)
KD-AR855BT
Rear output
Front output
Subwoofer output
Vehicle dashboard
Factory wiring
harness (vehicle)
Vehicle-specific Wiring
Harness (separately
purchased)
For more information:
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
28
KD-R950BT / KD-R850BT
Front output
Rear/subwoofer output
To the steering
wheel remote
control adapter
Recommended
connection
Blue: To power antenna
Blue/white: Remote (200 mA max.)
Blue/white: To amplifier
Orange/white: Illumination
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
White: Front speaker (left)
White/black
Gray: Front speaker (right)
Gray/black
Green: Rear speaker (left)
Green/black
Purple: Rear speaker (right)
Purple/black
Signal cord (not supplied)
Fuse (10 A)
Antenna terminal
Light blue/yellow
STEERING
WHEEL
REMOTE
Join the same color wires together.
(Not used) Insulate to prevent short circuit
Part list for
installation
JVC Amplifier (A) Faceplate
Remote wire
(not supplied)
(B) Trim plate
Microphone input
jack ( 13)
(C) Mounting sleeve
Ignition switch
(D) Wiring harness
Car fuse block
Separate
red wire
(E) Extraction key
Make this connection if
your vehicle factory wiring
harness does not have
"12 V ignition switch" wire.