Installing (Or Replacing) The Batteries - A&D Medical UC-351PBT-Ci Mode D'emploi

Installing (or Replacing) the Batteries

Open the battery compartment cover on
1.
the underside of the scale.
Install four new AA size alkaline batteries
2.
with the positive (+) and negative (-)
terminals properly aligned with the
corresponding symbols in the battery
compartment.
Close the battery compartment cover.
3.
 The scale switches to pairing mode when batteries are
installed.
To pair the scale with a receiver, see "Registering with a
Receiver (Pairing) (P.6)". If you do not want to pair the scale
with a receiver, see "Skip Registering with a Receiver
(Pairing) (P.7)".
 Install each battery with the positive (+) and negative (-) terminals properly aligned with the
corresponding symbols in the battery compartment.
 Improper installation of the batteries may cause battery leakage.
 Replace all four batteries with new ones, when the
 Do not mix new and used batteries. It may cause damage to the scale or shorten the battery life.
 Be sure to use AA size alkaline batteries. Do not use any other type of battery.
 Never use rechargeable batteries with this scale.
 The battery life is dependant upon the environmental temperature, battery type and usage.
 The batteries provided with the device are for testing the scale performance and may have a
limited life.
 Remove the batteries from the battery compartment, when the scale is not to be used for a long
time. Storing the scale with the batteries installed may result in battery fluid leaking from the
batteries, causing damage to the scale. The supplied batteries are for checking operation of the
scale and may have a short lifespan.
The scale has an "Automatic power-off" function.
 After the measurement results are displayed for 15 seconds, the scale is automatically turned off.
Caution
Automatic Power-Off Function
English 5
symbol is displayed.