Other Functions - A&D Medical UC-351PBT-Ci Mode D'emploi

Other Functions

Unpairing
Confirm that the scale is
1.
turned off, and press and
hold the setting switch.
 When the setting switch is
continuously pressed, "unit" and
"uPr" are alternately displayed.
Release the setting
2.
switch when "uPr" is
displayed.
Confirm that "End" is
3.
displayed.
 The receiver is unpaired.
 If "E-10" or "E-11" is displayed,
perform the unpairing procedure
again from step 1.
 The scale turns off automatically.
Transmitting Temporarily Stored Data
If measurement data cannot be sent to a receiver, this scale can temporarily store data of a maximum of
200 measurements in the built-in memory. When the scale is able to transmit to a receiver, all of the data
is transmitted. If the amount of data temporarily stored exceeds 200 measurements, the oldest data is
deleted and replaced with new data.
※ Stored data cannot be viewed on this scale.
※ The maximum amount of data that can be temporarily stored may differ depending on the receiver.
English 10
≪♪Beep≫
≪♪Beep≫
≪♪Beep beep≫