Operating Instructions; Mode Selection - Rotel U797CH2 Mode D'emploi

• OPERATING INSTRUCTIONS

Mode selection

COOL mode
o Press MODE until the COOL indicator lights on the panel.
o Press UP/DOWN to set the appropriate temperature within a range between 18°C
and 30°C (64 to 86℉). When UP or DOWN is pressed once, the temperature will
increase or decrease by 1°C or 1℉.
Press SPEED to select the appropriate fan speed, either LOW or HIGH.
o
o After selecting the COOL mode, press SLEEP on the remote control (or Timer button
+ Down button together on the control panel) to choose Sleep mode. Both upper and
lower fans are forcibly set at LOW speed. Under this mode, after the unit operates
for 2 hours, the setting temperature raises 1°C automatically. After operating for
another 2 hours, the setting temperature raises 1°C again. After that, the setting
temperature won't change. Press SLEEP again to cancel this function.
Caution:
o When WATER FULL indication is displayed, the air conditioner will stop operating until
the condensate water has been drained. After drainage, the air conditioner will start
automatically.
o If you turn the air conditioner off and immediately restart it, or in the event of a
power failure during use, allow 3 minutes for the compressor to restart cooling. There
is an electronic device in the unit that keeps the compressor turned off for three
minutes for safety.
DEHUMIDIFY mode
Press MODE until the DEHUMIDIFY indicator lights on the panel.
o
o Temperature and speed are not adjustable when this mode is selected.
Important: for best efficiency in dehumidifying mode, make sure that windows and doors are
kept closed.
FAN mode
o Press MODE until the indicator lights on the panel.
o Press SPEED to select appropriate speed. LOW and HIGH speeds can be circularly
selected (high > low > high).
o Temperature is not adjustable when this mode is selected.
o The sleep function is not available for the fan mode.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instructions for use
63