Publicité
Hand pallet truck PROLINE
English
Operating instructions
Functional description
The pallet truck is a manually operated hydraulic
device.
The load lifts by manipulating the pump lever.
Easy manoeuvrability due to steering rollers of solid-
rubber resp. Polyurethane and fork rollers of
Polyamide resp. Polyurethane.
The control lever in the handle can be set to three
different positions.
- LIFTING – LOWERING – DRIVING -
Operating:
1)
Hand pallet truck HU 15-115 FTP
Due to this equipment's particular geometry, a very noticeable slant to the hydraulics occurs once the
maximum stroke is reached. To best handle or compensate for this condition, pallets should only be raised
from the floor and not raised to their maximum lifting height.
Moving and steering using the steering handle
The steering handle is connected to the steering rollers.
The wheels are steered automatically by moving the steering handle.
Picking up a load
Check that the load does not exceed the loading capacity of the pallet
truck.
Roll the pallet truck slowly up to the pallet/load. Roll the fork prongs under
the pallet until the back end of the fork rests against the load (pallet). Lift
the load by executing the pumping movements shown.
Load distribution
The load must be evenly distributed across both prongs of the fork.
Moving with the load
As the pallet truck is not equipped with a brake it must not be used on
upward or downward slopes.
As far as floor/ground clearance permits, the load should be transported
across the floor/ground at as low a height as possible.
Move at a uniform speed appropriate to the load and floor/ground conditions.
3)
The pallet truck Type HU 25-115 FBTP is equipped with service and parking brake
This pallet truck is equipped with an efficient brake.
This brake works like the standard drum brake
Control is progressively activated by pulling the brake lever mounted on the
steering handle.
On request, other pallet trucks PROLINE with driving and parking brake
can be delivered.
Setting the load down
Lower the load by applying the operating lever in the handle. Check that the
way is not blocked behind, and then move the pallet truck away.
When the pallet truck is in the parked position the load must be lowered to the
floor/ground. The operator must ensure that the pallet truck is securely immobilized.
This should normally be done by bringing it to a controlled stop on a flat
floor/ground surface. If the unladen pallet truck is parked on an uneven or slightly
sloping floor/ground surface, measures must be taken to prevent the pallet truck
from rolling away. This can be done by parking it against the load with the load on
the downside of the slope, by placing wedges against the rollers or by using a
parking brake (not included as standard with the contents of delivery).
The operator is responsible for ensuring that the pallet truck is securely parked.
Technische Änderungen vorbehalten
034527124;
Type
Design changes under reserve
F 08.01.115
lowering
pump movement
Lowering position
driving
Driving position
lifting
Lifting position
Sous réserve de modifications techniques !
9
Publicité
