Installation And Use; Safety Instructions; Use - Casselin CTJ195B Mode D'emploi

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
Manual :
- The device must be completely removed from its packaging. All protections must be completely removed.
Install the device in a room with an ambient temperature between + 5 ° C and + 32 ° C
- Place the appliance upright on a solid, flat surface. Never put the slicer on a flammable surface.
- Do not install this device near open fires or other heating devices.
- Place the device 80 CM high
- The electric cable must be protected to at least 16 amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
- Make sure that there is sufficient space for use before switching on the device. Position the device and
ensure that the user is standing up each time it is used. The appliance must be installed on a clean, tidy,
stable and dry work surface.
- Connect the appliance to a single earthed socket. Once plugged in, turn on the device using the Start
button.
- Before use, leave the device on for 3 minutes to check for any malfunction.
- Switch off the appliance, place the product to be sliced on the plate by lifting the clamping handle
- Using the thickness regulator, choose the thickness of your slices.
- Once the product has been installed, correctly fixed thanks to the clamping handle, and the thickness
adjusted, connect the appliance and then using the clamping handle and the fixed handle, move the trolley
slowly and evenly. It is strictly forbidden to move food on the slicer without holding the clamping handle
firmly. Failure to comply with this instruction may result in serious injury.
- The slice then falls on the slice plate.
- After finishing the cut,
NOTE
EN