Installation And Use; Safety Instructions; Use - Casselin CSQA2P Mode D'emploi

5. INSTALLATION AND USE

5.1 Safety instructions

ELECTRICAL HAZARD
Danger from electric current!
• No contact with heat sources should take place with the power cord.
• Cord should not hang over edge of table or counter.
• Do not pour water into an appliance that is in operation or that is still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
In operation, the device can reach high temperatures. To avoid burns and accidents, do not use the device
in malfunction, and do not use spare parts that are not original.
ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
• Do not leave the appliance running without supervising it.
• During use, your hands should be dry.
• Do not move or tilt the device during operation.
MANUAL
START-UP
The device must be completely removed from its packaging. All protections must be completely removed.
Place the device on a solid, flat surface. Never place the Salamander on a flammable surface.
Do not install this appliance near open fires, or other heating appliances.
The electric cable must be protected to at least 16 Amps. The device must be plugged directly into a wall
outlet. Using a multiple socket will cause the device to trip.
Heat the appliance for 10 minutes until all smoke and odors are gone.
USE
Plug in the device, once plugged in, the red LED will light up.
Turn the temperature control knob and green light will come on.
When the desired temperature is reached, the green light goes out.
When the temperature decreases, the appliance will start heating again and the green light will come on
again.
Installation:
- Installation must be carried out by a certified professional.
- The device must be completely removed from its packaging. All protections must be completely removed.
- Place the appliance upright on a solid, flat surface. Never place the appliance on a flammable surface.
- Do not install this device near open fires or other heating devices.
- It is forbidden to place inflammable objects on the appliance or within a distance of less than 10 cm from
the appliance.
Safety distances for flammable materials according to their degree of flammability:
A non-flammable
B hardly flammable
C1 poorly flammable
granite, sandstone, concrete, bricks, ceramic tiles, plaster.
acumin, heraclitus, lihnos, itaver
wood from feillus trees, plywood, hardened paper, umakart
EN