Beper 40.985A Manuel D'instructions page 14

Hair clipper Use instructions
The blades (1) have been aligned and oiled in factory. To maintain your clipper in peak condition, the
blades should be oiled every few haircuts and could be useful to make a new alignment.
Unscrew and take off screws. Fig.8
To realign the blades, simply match the upper and bottom blades teeth up. Point for point. (End
of top blade teeth should be approximately 1.2mm back from bottom blade. Compare your clipper
blades with the sketch.
Screw firmly the screws. Fig.9
TECHNICAL DATA
Power 9W
Power supply 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), re-
quires that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the reco-
very and recycling of the materials they contain, and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation,
that when you dispose of the appliance, it must be separately collected.
14