EINHELL BT-PO 1100/1 E Instructions D'origine page 18

If you experience an unpleasant feeling or skin
discoloration on your hands while using the ma-
chine, stop your work immediately. Take adequate
breaks from your work. If you do not take ade-
quate breaks from your work, you could develop
hand-arm vibration syndrome.
You should evaluate the level of strain in relation
to the work involved and the use of the machine
and take adequate work breaks accordingly. This
will enable you to signifi cantly reduce the level
of strain over the whole period of work. Minimize
the risk to which you are exposed from vibrations.
Look after this machine with care in accordance
with the operating instructions.
If the machine is deployed or used often, you
should consult your dealer and possibly consider
obtaining anti-vibration accessories (handles).
Do not use the machine at temperatures of
t=10°C or lower. Think out a work plan which ena-
bles you to limit your exposure to vibrations.
A certain level of noise nuisance is inevitable with
this equipment. Carry out noise-intensive jobs
at times that are acceptable and allowed. Where
applicable, observe rest periods and restrict your
working time to a minimum. Suitable ear protec-
tion must be worn for your own safety and for the
safety of others nearby.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Assembly (Fig. 4-7)
Important! Pull out the mains power plug before
starting the assembly work.
Anl_BT_PO_1100_1_E_SPK1.indb 18 Anl_BT_PO_1100_1_E_SPK1.indb 18
GB
6. Operation
Secure your workpiece. Make sure that the work-
piece is held securely by a clamping device or a
vise.
Switching the equipment ON/OFF
The equipment is turned on (I) and off (0) with
the ON/OFF switch (Fig. 3 / Item 3). However, the
equipment will only start running after the speed
control has been activated (see section 6.3).
6.1 Using as a polishing machine
When using waxing and polishing agents,
observe the instructions issued by their ma-
nufacturer!
IMPORTANT!
To prevent damage to the surfaces of the work-
pieces you wish to polish, make sure that you
observe the following instructions:
•
Make sure that the polishing attachment is
always mounted precisely in the center of the
sanding/grinding disk.
•
Before you start the equipment, check to
ensure that the attachments are securely ins-
talled.
•
Never touch the area you wish to polish with
the edge of the sanding/grinding disk.
•
Use the speed selector (Fig. 3/Item 4) to
select the following maximum speeds for poli-
shing:
- Working in polish: approx. 1000 rpm
- Polishing to a
high gloss: approx. 1000-1100 rpm
- Polishing up: approx. 1400 rpm
If you do not comply with these instructions, the
manufacturer cannot accept any liability.
The Velcro fastener enables easy changing of the
polishing attachment.
Use the foamed plastic attachment to apply
the polishing agent (Fig. 8).
•
Make sure that the foamed plastic attachment
is free of any foreign bodies.
•
Spread the polishing paste evenly over the
polishing pad. Do not apply the polish directly
to the polishing surface.
•
Switch the polishing machine on and off only
when the polishing machine is resting on the
polishing surface.
•
Place the extension lead over your shoulder
- 18 -
21.06.16 07:04 21.06.16 07:04