Publicité
Les langues disponibles
Les langues disponibles
EN
Removing the battery from the machine (Fig. B)
• Push the battery unlock buttons (3) and pull the
battery out of the machine like shown in Fig. B.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• Insert the battery (2) into the base of the machi-
ne as shown in Fig. B.
• Push the battery further forward until it clicks
into place.
Charging the battery with the charger (Fig. C)
• Plug the charger plug into an electrical outlet and
wait for a while. The LED indicator on the charger
(6) will lighten up and show the charger status.
• Plug the output of the charger into the round
socket of the battery.
LED indicator (6) (Fig. C)
The charger has 1 LED indicator (6) which indicates
the status of the charging process:
LED
Charger status
Red
Battery charging in progress
Green
Battery charging finished, battery fully charged
• Fully charging the 1.3Ah battery may take up to
60 minutes.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Fitting and removing drills or screwdriver bits (Fig. D)
Always remove the battery before mounting
an accessory.
The drill chuck (7) is suitable for drills and screw driver
bits with round shaft as well as hexagonal shaft.
• Hold the machine firmly with one hand
• Open the drill chuck (7) by rotating the chuck
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
• Insert the shaft of the drill or screwdriver bit.
• Tighten the drill chuck again by firmly rotating
8
the chuck (7) counterclockwise.
• Check if the bit is centered well by shortly acti-
vating the machine´s on/off switch.
Adjusting the gears (Fig. D)
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between both
positions, this will damage your machine.
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (8) forward
or backwards. The number on the gear switch (8)
shows which position is chosen.
• Position 1: For slow drilling, large drilling dia-
meter or screw driving. The machine has high
power at a low speed.
• Position 2: For fast drilling or small drilling
diameter
Adjusting the direction of rotation (Fig. E)
• Set the direction switch (9) to position
order to drive screws or to use it for drilling.
• Set the direction switch (9) to position
order to remove screws.
Switching the machine on and off (Fig. E)
The on/off switch (10) is used for activating the
machine and adjusting rotation speed.
• Pressing the on/off switch (10) will activate
the machine, the further the switch is being
pushed, the faster the drill will turn.
• Releasing the on/off switch (10) will stop the
machine.
• Move the direction reversing switch (9) to the
middle position to lock the movement of the on/
off switch.
Adjusting the torque (Fig. E)
The machine has 17 different torque settings and a
special drill mode to set the power being transmit-
ted to the chuck.
By rotating the torque adjustment ring (11), screws
can be driven to a predetermined depth, which is
ideal for repetitive work. The higher the number,
the more torque will be transmitted.
• Select a low setting for small screws or soft
work material.
in
in
WWW.VONROC.COM
Publicité
