Connection; Connection To Evis Video System - Olympus OEV143 Mode D'emploi

Connection

Connection to EVIS Video System

RGB/COMPONENT A connectors
RGB/COMPONENT B connectors
1
Connect the monitor cable to the MONITOR connector
of the video system center.
2
Connect the end of the monitor remote cable (MAJ-
227) labeled "MAJ-227" to the MONITOR REMOTE
connector of the video system center as shown in the
figure.
3
Connect the monitor cable to this unit as shown in the
figure.
4
Connect the end of the monitor remote cable labeled
"to OEV" to the REMOTE 1 connector of this monitor.
10
N
LINE A
AC IN
VIDEO AUDIO
IN OUT IN
R/R–Y
A
IN OUT IN
R/R–Y G/Y B/B–Y
B
IN IN IN
RGB/COMPONENT
R
Monitor cable
Monitor INPUT/OUTPUT connectors
Y/C
LINE B
Y/C
OUT IN OUT
G/Y B/B–Y AUDIO
OUT IN OUT IN
AUDIO EXT SYNC
RS-232C
IN IN
B
G
Monitor remote cable
Notes
— Connect the R/G/B/S connectors to the RGB/
COMPONENT A connectors of this monitor. If they are
connected to the RGB/COMPONENT B connectors, the
Monitor Remote Control will not function.
— When the monitor remote cable is connected to the
EVIS video system center and you press the SELECT
switch on the front panel, some front panel switches
(RESET, UNDER SCAN, OVERSCAN and SPLIT)
will not function.
AUDIO
IN OUT
EXT SYNC
OUT IN OUT
DC OUT REMOTE 1
8V/0.8A
REMOTE
S
to OEV
to OEV
MAJ-227