Argo AFIAS11DC V2 Mode D'emploi page 8

3742540641-U-AFIA-BS11DC-V2
HIGH POWER MODE
When this mode is active the internal fan speed is set
automatically and the air conditioner operates at the
maximum power in the selected operating mode (cooling
or heating).
NOTE
During the high power operation the room temperature
could not correspond to the set temperature.
EG
SETTING THE TIMER
A) HOW TO SET THE ON TIME
1. Press the ST button once.
The ON and time indications flash.
2. Press the H button until the designed
hour is displayed.
Press the M button until the designed
minutes are displayed. The display will
change automatically back to show the
present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the button to activate the ON
timer.
B) HOW TO SET THE OFF TIME
1. Press the ST button twice.
The OFF and time indications flash.
2. Press the H button until the designed
hour is displayed.
Press the M button until the designed
minutes are displayed. The display will
change automatically back to show the
present time after 10 sec.
3. Press the ON/OFF button to start the air
conditioner.
4. Press the button two times to
activate the OFF timer.
C) HOW TO SET A PROGRAM FOR
DAILY ON/OFF OPERATION (OR
VICEVERSA)
1. Set the timer ON/OFF as shown in A)
and B).
2. Press the ON/OFF button to start the air
conditioner.
3. Press three times the
activate the DAILY timer.
NOTE
After timer setting, press ST button in order to check the
ON/OFF setting time.
20-07-2015 8:46
This function causes the unit to operate for one hour at the
set conditions, regardless of whether the unit is on or off.
TIMER SETTING PROCEDURE.
l
CANCELLATION PROCEDURE
l
l
l
The Holiday Timer function allows you to activate the indoor
unit (either it is the only one of a monosplit system or one
unit of a multisplit system), with a dalay up to 99 days you
can set for the Daily Timer, On Timer, Off Timer functions
(not available for 1 HOUR TIMER) already explained in this
manual.
With this function you can set the air conditioner to be
switched on again after a long week end, a holiday of one
week or more, ecc...
To activate this function you have to follow the following
C
steps in order :
1. Keep pressed the button "TIMER SELECTION" of the
3
2. Select the desired timer (Daily Timer, On Timer, Off
2
2
1 4
3. Set the desired number of days of delay using the button
4. Keep pressed again the button "TIMER SELECTION" for
At this point, the symbol of the desired timer will flash and
the selected timer will be activated only after the set number
of delay days.
button to
8
Pagina 8
SETTING THE 1 HOUR TIMER
Press four times the button.The 1
HOUR TIMER mark will appear on the
display.
Press the ON/OFF button to turn the air conditioner off.
Wait for the indoor unit to stop operating.
Press the ON/OFF button again to turn the air conditioner
on.
SETTING THE HOLIDAY TIMER
remote control unit (clock figure) for more than 6~7
seconds. In this way you enter the menu to select the
number of days of delay.
Timer) pressing on the same button "TIMER
SELECTION".
"+" .
more than 6~7 seconds. You enter again the normal
menu of the remote control unit.
C
3
1 - 2 - 4