Sharp PN-R903A Manuel D'installation page 2

The wires in this mains lead are coloured in accordance with the following code:
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the
terminals in your plug proceed as follows:
• The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the
letter E or by the safety earth
• The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black.
• The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red.
Ensure that your equipment is connected correctly. If you are in any doubt consult a qualified electrician.
"WARNING: THIS APPARATUS MUST BE EARTHED."
WARNING:
The temporary stands used in the package for transportation are only designed for the transportation of the monitor while
within the Carton.
The temporary stands used in the package for transportation are not designed to support the monitor outside of the Carton.
This monitor must be either Wall Mounted or Attached to the SHARP recommend Floor Stand.
(Example: Model No.PN-ZS80N)
Note The SHARP Floor Stand is tested to comply with AS/NZS 60950 for Stability
FOR CUSTOMERS IN U.K.
IMPORTANT
GREEN-AND-YELLOW:
BLUE:
BROWN:
or coloured green or green-and-yellow.
Earth
Neutral
Live
Australia and New Zealand Only