Installation Instructions - Novy Super Flex Zone 3762 Mode D'emploi Et D'installation

INSTALLATION INSTRUCTIONS

The installation is the exclusive responsibility of specialists.
The user of this appliance is held to respect the legislation and the standards enforced in his home
country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
Its installation has to be done carefully, in accordance with the illustration below.
Fitting - installing:
 The dimensions are:
Type Cut size
Width
3762 350
3772
370
 Ensure that there is a distance of 50 mm between the hob and the wall or sides.
 The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall at
one side. On the other side, however, no unit or device can be higher than the hob.
 The piece of furniture or the support in which the hob is to be fitted, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
 The strips on the mural edges need to be heat-resistant.
 Do not install the hob above a non- ventilated oven or a dishwasher.
 To ensure good air circulation of the electronic device, maintain a space of 20 mm under
the bottom of the hob casing.
 If a drawer is placed under the work, avoid putting flammable objects in this drawer (e.g.
sprays) or non-heat-resistant objects.
 Materials which are often used to make worktops expand on contact with water. To protect
the cutout edge, apply a coat of varnish or special sealant. Particular care must be given
when applying the adhesive joint supplied with the hob to prevent any leakage into the
supporting furniture. The gasket guaranties a correct seal when used in conjunction with
smooth worktop surfaces.
 The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. Respect a distance of at least 760 mm if you do not
have further instructions.
 The connection cable cannot be subjected to mechanical constraint (e.g. a drawer) after
construction.
Flush mounting
Depth Width Depth
490 386 526
490 386 526
Stick the gasket (2) two millimetres
from the external edge of the glass,
after removing the protection sheet (3).
Radius Width
8 380
8 380
61
Glass size
Depth Thickness
520 4
520 5.4