Ryobi RY40500 Manuel D'utilisation page 13

To install:
 Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw's battery port.
 Make sure the latch on bottom side of the bat-
tery pack snaps in place and that battery pack is
secured in chain saw before beginning operation.
WARNING:
Make sure the latch on the bottom of the bat-
tery pack snaps in place and the battery pack
is fully seated and secure in the chain saw bat-
tery port before beginning operation. Failure
to securely seat the battery pack could cause
the battery pack to fall out, resulting in serious
personal injury.
To remove:
Locate latch on bottom of battery pack and depress
both sides to release the battery pack from the
chain saw.
NOTICE:
When placing battery pack in your chain saw,
be sure raised rib on battery pack aligns with
groove in chain saw's battery port and latches
snap in place properly. Improper assembly of
battery pack can cause damage to internal
components.
NOTICE:
Remove battery pack from unit. Fill oil tank with
Ryobi Bar and Chain Lubricant before starting
the chain saw. Failure to lubricate the chain will
cause damage to the bar and chain.
CHAIN OIL SYSTEM
See Figure 7.
 Use Ryobi Bar and Chain Lubricant. It is formu-
lated to perform over a wide temperature range
with no dilution required.
NOTE: Do not use dirty, used or otherwise contam-
inated oils. Damage may occur to the bar or chain.
 Carefully pour the bar and chain oil into the tank.
 Check and fill the oil tank when battery is
recharged, or as needed.
OPERATION
BATTERY
NOTE: It is normal for lubricant to seep from the
saw when not in use. To prevent seepage, empty
the oil tank after each use. When storing the unit
for a long period of time (three
sure the chain is lightly lubricated; this will prevent
rust on the chain and bar sprocket.
STARTING AND STOPPING THE CHAIN
SAW
See Figure 8.
WARNING:
Keep body to the left of the chain line. Never
straddle the saw or chain, or lean over past the
chain line.
Starting the chain saw:
 Place the chain saw on a flat bare surface and
make sure no objects or obstructions are in
immediate vicinity which could come in contact
with the bar and chain.
 Press and hold the lock-out button. This makes
the switch trigger operational.
13 - English
PORT
months or longer) be
BATTERY
PACK
LATCH
Fig. 6
Fig. 7