Marmitek AM12 Guide Utilisateur page 4

FAQ
What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your neighbours using the
same House Code. To solve this problem try to change the House Code of your system, or
have FD10 Phase Coupler/Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are set to the same House
Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13 Transceiver or
Marmitek Security Console installed in your house. These components will translate the radio
signals to the Marmitek X-10 signal on the power line. Only one Transceiver should be
installed for all remotes and sensors set to the same House Code.
Am I able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your remotes is
not sufficient. The TM13 is using so called collision detection to prevent signals to be disturbed when
more than one TM13 is transmitting. TM13's will wait for a quite power line before transmitting their
data. To prevent your Marmitek X-10 System to become slow or to prevent dimming from becoming
less smooth, make sure that the TM13 units are placed as far away from each other as possible.
Do the Marmitek plug modules work in unearthed wall power points ?
Yes. The modules work both in earthed and unearthed wall power points.
My module does not respond to the 'All lights on' command.
That's right. Only lamp modules will respond to the command 'All lights on'. This is to prevent
that for instance a coffeemaker is switched on accidentally. Apparatus modules do respond to
the command 'All Units Off'.
Do you still have questions? Please check out www.marmitek.com for more information.
Technical data
Supply voltage:
Supply current :
Making capacity:
Signal sensitivity:
Responds to X-10 Key codes: All Units Off, On, Off.
Input impedance:
Ambient temperature:
Dimensions:
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its
packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product
should be disposed of separately from regular household waste streams. It is your responsibility to dispose
of this and other electric and electronic equipment via designated collection facilities appointed by the gov-
ernment or local authorities. Correct disposal and recycling will help prevent potential negative consequences
to the environment and human health. For more detailed information about the disposal of your old equipment,
please contact your local authorities, waste disposal service, or the shop where you purchased the product.
4
230V ±10% 50 Hz
< 20 mA capacitive
500W (incandescent lamps and halogen light)
230W (motors)
3600W (resistive loads)
15 mVpp min 50 mVpp max at 120 kHz
> 180 Ohm (L - N) at 120 kHz
- 10° C to + 50° C (operation) - 20° C to + 70° C (storage)
52x122x33mm (without plug)
© MARMITEK