Lighting; Remote Control - Novy Pure'line Cubic 6838 Mode D'emploi

Switching extraction off without delay mode
Press key twice.
1
Extractor power level
To increase the power level press key
To decrease the power level press key
− Three green LEDs 5 show positions one to three.
6
− The red LED shows the Power position. The Power
position is only used if there are strong odours, or a lot
of smoke or vapour. Its use must be kept to a minimum
because of the large extraction of air in this position.
− The Power position automatically goes back to speed
three after 6 minutes.
− The motor has a thermal switch that switches the motor
off with overheating. After cooling the motor will switch
on again.


Determining the cause of overheating is re-
quired. This can be caused for example by a
pan fi re, the impeller motor being blocked or
an object getting in the exhaust opening and
causing it to be partly or fully blocked.
Auto-Stop
To avoid the extractor hood from staying on, the motor is
automatically switched off after 3 hours (only if in 3 hours
operation has not been changed). The extractor hood
lighting stays on.

2.3 Lighting

Turning the lighting on and off
Extra lighting (max. 300W) can be connected to the cooker
hood.
To turn the lighting on or off press
The light works independent of the motor.
.
3
.
2
.
4
– 36 –

2.4 Remote control

➀ Lighting (if extra lighting
is connected)
➁ Increase speed levels
➂ Decrease speed levels
➃ Switch on / off
➄ Novy button: not applicable
The remote control for hood is preinstalled and ready for use.
Change the code on the remote control
If the set code disrupts other transmitters, another code
can be selected using the remote control. There are 10
different codes.
Determine the code used
Simultaneously press and
control fl ashes as many times as the selected code (there
are 10 code options in total).
Change the code
− Simultaneously press and
− The green light on the remote control fl ashes as many
times as the selected code. If another code is required
repeat this step again (1x fl ashing is code 1, 2x fl ashing
is code 2 etc. There are total of 10 codes).
− Simultaneously press on the cookerhood
until the second green Speed indicator lamp is blinking.`
− Press the key on the remote control within 10 seconds
to confi rm the settings. The cooker hood and the remote
control are now in line with each other.
. The lamp on the remote
and .
and