Evolite ArchiTECH 270 Mode D'emploi page 13

DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or
one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried
out in compliance with IEC standards.
 Set up
Control panel
o
The control board offer several features: you can simple set the starting address, run the pre-
programmed program or make a reset.
The main menu is accessed by pressing the Menu button, Browse through the submenu by pressing
Up or Down. Press the Enter-button in order to select the desired menu. You can change the
selection by pressing Up or Down, confirm every selection by pressing the Enter-button. The
functions provided are described in the following setting.
ArchiTECH 270 Manual Ver. 1.00
13
Page