LD Systems VIBZ 8 Manuel D'utilisation page 9

31
MAIN MIX OUT
Unbalanced stereo line output with 6.3 mm jack sockets to connect an active PA system. Output of the master signal of the mixer.
32
2 TK OUT
Unbalanced stereo line output with RCA sockets for connecting an external recording device (e.g. laptop). Output of the master signal of the mixer.
33
MAIN MIX
Volume controller for the stereo line outputs MAIN MIX OUT (N 31) and 2 TK OUT (N 32) Press the Fader button upwards to increase the
volume, and downwards to decrease it. Before you turn on the power of the connected PA system, set the volume controller to minimum.
34
OUTPUT LEVEL
8-segment LED level display for visualising the volume level of the stereo sum channel. To avoid distortion, reduce the volume level of the
output channel as soon as the red CLIP LED lights up.
35
AUX SEND
Unbalanced mono line output with 6.3 mm jack sockets to activate an external effects device (POST Fader). When using the AUX SEND jack
socket, the internal effects device is automatically bypassed, and is therefore not usable.
36
+48V ON / OFF
+48 V phantom power supply for operating high-quality condenser microphones without own power supply. Press down to select the ON
position (red LED light is on) to turn on the phantom power for the XLR microphone inputs, and return to the original OFF position to turn
it off (red LED light is off). Turn on the phantom power only after connecting a microphone, or off after disconnecting, and set the volume
controller of the channels 1 to 4 to minimum before this step.
37
AC ADAPTOR IN
Screwable low-voltage socket for the power supply of the mixer. Please use only the supplied AC power supply to avoid damage to the
mixer. Turn on the mixer only after connecting the power supply to the mains and the low-voltage socket. The mains voltage of your power
supplier and the operating voltage of the device must be the same!
38
POWER ON / OFF
On / Off switch for the power supply of the device.
39
POWER LED
The power LED lights up once the system is properly connected to the power mains and is switched on.
Note: A mounting point for the optional microphone stand adapter LDVIBZMSADAPTOR is located on the underside of the device.
LDVIBZMSADAPTOR
9